Maintenance; Part Description - Husky GM UPRIGHTS Assembly, Installation And Operating Instructions

1. After coupling, always visually check that the slide bar or the jaw has closed completely across the
rear of the king pin and that the indicators are working properly.
IMPORTANT! All indicating features should work when you are done hitching up for travel.
2. After the first 100 miles, and at least once a year thereafter, inspect all bolts for proper tightness. Re-
tighten nuts if needed.
3. Once or twice a week when traveling, apply a few drops of lubricant to the pivot areas of the hitch.
4. Once or twice a year, apply a light coating of wheel bearing grease to the surfaces of the slide bar that
holds the king pin in place. For best results, apply the grease with the slide bar or jaw surfaces of the
5 th wheel in the closed position.
Caution: The slide bar & jaws can close with heavy force. Use extreme care to keep fingers,
hands, extremities & clothing out of the path of the slide bar. Failure to do so could result in
severe injury.
5. Periodically inspect your product for wear or damage. If excessive wear or damage is found, contact
your installing dealer or send proof of purchase and photo of wear and damage to HUSKY technical
support staff at www.huskytow.com
6. Husky Towing Products recommends the use of a lube disc, contact your local Husky dealer to
purchase one.
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information /
Tech Support / Product Updates. 2021 Keystone Automotive Operations Inc. All Rights Reserved. 05/17/2021-Rev1

Maintenance

or 1-877-544-4449.
ITEM #

PART DESCRIPTION

1
2
3
HANDLE ASSEMBLY
4
5
1"-14 JAM NUT
6
3/16" LOCK PIN
7
¾"-10 X 1-3/4" SOCKET HEAD CAP SCREW
8
¾"-10 NYLOCK HEX NUT
9
5/16" LOCK PIN
10
11
UPRIGHT
ADAPTOR
T-BOLT
TAB WASHER
SPACER
- -
- -
- 1
- 1
- 1
- 1
- 1
4 -
4 -
- 1
- 1
Page-9