Husky 33056 Assembly, Installation, Operation And Maintenance Instructions page 4

4. Install the uprights and cross member for your hitch into the adapters. Do not fully torque the bolts for the cross
member at this time, only lightly snug them.
5. Install a "Foot Hook" , ½" Flat Washer and 1/2-13 Nylock Nut on each adapter as shown in the picture below.
make sure the hook passes through the hole in the upright tab and is centered in the adapter guide slot.
Torque the ½-13 Nylock Nuts to 50 ft lbs.
NOTE: Husky brand
uprights and cross
member shown for
illustration only. Your
installation may be
different.
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information /
Tech Support / Product Updates. ©2017 DTS Manufacturing. All Rights Reserved. August 2, 2017‐Rev3 Page‐4
Truck bed NOT shown for clarity
Cross Member
Tab
Guide slot