Advertisement
3M
™
Uni-Presser Blade Replacement
Old Blade Removal
With the "T" bar in the "Up"
position, use the hex nut wrench
(fig. 4 #5) to remove the four
(4) screws (fig. 2 #3) at the rear
of the uni-presser head.
Apply thumb pressure and remove
old blade assembly. (fig. 1 #11)
BLADE FRONT
FACING UP
While holding back the blade
guard (fig. 2 #15) use finger
pressure on the metal ends and
insert the new unit into the "T"
bar. Caution: Sharp blades -
do not touch the cutting
blades. (fig. 1#11)
New Blade Replacement
Blade and holder is a one piece unit.
Starting at the center of the "T"
bar, line up the new matching
one (1) blade to one (1) stuffer.
12
With the"T" bar in the open
position loosen two (2) screws
(fig.3 #3) on the front cover of
the unipresser head. (DO NOT
REMOVE THE SCREWS.)
A
(fig. 4 #1)
With the :"T" bar in the open
position, tighten the two (2)
screws (fig. 3 #3) on the front
cover enough to secure the
blade unit inside the head.
78-8125-3042-2-B
Advertisement
