Accessory Items; Replacement And Removing Input Wriststrap Dual Conductor Input Jack - 3M Wrist Strap and Ground Monitor 773 User Manual

Section 8.0 Accessory Items
3M Product Number
2368
2360
2370
Workstation Checker CTE701
3M
™
APD12X
Use of a dual conductor wrist strap system allows for monitoring a person
continuously while they are being grounded. It allows for the voltage and resistance to
be measured simultaneously. If any fault condition is noticed, a person can stop and
locate the cause for insuffi cient grounding of the person. This will prevent possible
further damage to the components, printed circuit boards or equipment they are
working on.
Replacement and Removing Input Wrist Strap Dual
Conductor Input Jack
If the wrist strap input jack begins to show wear after heavy usage, the input jack can
be replaced by ordering input jack part number above. Remove the input jack in the
unit by removing the locking collar and two screws on front cover. Slide the printed
circuit board outside of the unit and unplug the pin connector with input jack board.
Plug in new input jack board assembly and carefully slide the board back into the
housing. Replace front cover and locking collar on the input jack.
Description
Dual Conductor Fabric Adjustable Wrist Band
Dual Conductor Coiled Ground Cord, 5ft.
Dual Conductor Coiled Ground Cord, 10ft.
Workstation Monitor Checker
Dual Conductor Input Jack Board Replacement
17