PowerCube 5000 (SUN2000-150KTL-S0)
Installation Guide
Step 2 Connect the signal cable from the battery temperature sensor to the BTEMP terminal on the
UIM02C, as shown in the following figure.
Figure 7-21 Installing the signal cable for a battery temperature sensor
----End
7.9 Installing AC Input Power Cables
Prerequisites
AC input power cables need to be installed when a backup DG is available.
Procedure
Step 1 Prepare a suitable length cable based on site requirements. Install a cord end terminal or an
OT terminal on each end of the cable.
Step 2 Install AC input power cables.
Issue 03 (2020-04-10)
Ensure that the upstream AC input circuit breaker is OFF, and attach labels such as "No
operations allowed."
Switch off all circuit breakers before installing power cables.
Copyright © Huawei Technologies Co., Ltd.
7 Installing Cables
63