Zodiac PM40 Series Instructions For Installation And Use Manual page 20

2.4.4 Setting the time
• Press for 5 seconds to set the time.
The hours flash to show that they can now be changed.
• Set the hours using the
• Press to confirm the hours setting.
Once the hours have been confirmed, the minutes begin to flash.
• Set the minutes using the
• Press to confirm the minutes setting.
2.4.5 Programming "TIMER"
Up to three different "TIMERS" can be set for the PM40 heat pump.
Setting "TIMER" 1, 2 or 3:
• Press to set "TIMER 1".
The hours start to flash with the
• Set the hours using the
• Press to confirm the hours setting.
Once the hours have been confirmed, the minutes begin to flash.
• Set the minutes using the
• Press to confirm the start time setting and proceed to setting the stop time (
• Repeat the same steps as above to set the stop time (
• Press to confirm the settings for "TIMER 1".
• Press then
• Press to set "TIMER 2" or "TIMER 3".
• Follow the same steps for setting "TIMER 1" in order to set "TIMER 2" and/or "TIMER 3".
Disabling "TIMER" 1, 2 or 3:
• Previously select the TIMER to be disabled using the
• To disable the "TIMER", set the start time
steps indicated in the paragraphs for setting the "TIMER".
18
or keys.
or keys.
indicator (to set the start time).
or keys.
or keys.
, the symbols start to flash.
and stop time
indicator lit) for the "TIMER".
key then to select "TIMER" 1, 2 or 3.
for the "TIMER" to the same time by following the
indicator lit).