Description Of The Charging Station; Charging A Vehicle; Meaning Of The Status Led Colors; Connecting Charging Cable - Wallbe Driving eMobility Eco 2.0 Instruction Manual

Instruction Manual
permitted to qualified personnel or persons instruc-
ted by qualified personnel to open the charging sta-
tion.
• Do not use the charging cable with an extension cord
or adapter.
• Always make sure to remove the charging cable
from the vehicle before driving off.
• Any changes to the charging station are not permit-
ted. There is a risk of electric shock and damage to
the charging station. Any changes to the charging
station will void the warranty with immediate effect.
• Never clean the charging station with harsh cleaning
agents, high pressure water jet cleaners and steam
jet cleaners
• Never immerse the charging cable in in water or any
other liquid
• Assembly, electrical connection, commissioning,
maintenance and repair may only be carried out by a
qualified electrician. The qualified electrician must be
registered in the installer directory.
• If further trades are required for assembly, the ne-
cessary activities may only be carried out by trained
specialists.
• No liability will be accepted for damage during trans-
port if the product is transported in anything other
than the original packaging.
• At all times, observe the local safety regulations for
the country in which you operate the device.

3 DESCRIPTION OF THE CHARGING STATION

The following figure shows the wallbe® Eco 2.0 char-
ging station. Depending on the variant ordered, the op-
tical appearance differs from the figure.
Driving eMobility
Figure 1: Overview of wallbe® Eco 2.0
A
Plastic housing
B
Type 2 socket
Charging stations with firmly attached
charging cable: Parking position for charging
plug
C
Status LED
D
Key switch

4 CHARGING A VEHICLE

4.1 Meaning of the status LED colors

The charging station has a status LED that displays the
current status of the charging station. The colours of
the status LED represent the following states:
LED shines green,
the charging station is ready for use.
LED flashes alternately green and blue,
authorization and release phase
LED shines blue,
the vehicle is being charged. You can find
out how far the charging process has pro-
gressed from the charging indicator of your
vehicle.
LED shines red,
the charging station has detected an error.

4.2 Connecting charging cable

!
WARNING: Ensure that the charging cable, when
connected to the charging station and the vehicle, does
not block any paths.
!
WARNING: Pay attention to the charging cable ly-
ing on the ground when the charging cable is connec-
ted to the vehicle and charging station. There is a risk
of tripping.
A
B
C
D
4/13