Makita DPB181 Technical Information page 18

W
iring diagram
Fig. D-5
Put the above Lead wires to the place
between Inner wall and Ribs I, H and G.
Pass Lead wires (black, orange)
connected to DC Motor through
Line filter and put Line filter to
the room surrounded by ribs.
Except for the Lead wires (balck,
orange), any lead wires must not
be put in the room.
Controller
Terminal
Rib A Rib B
Put the following lead wires between Rib A and Rib B.
* Lead wires (blue, red) from DC motor
* Lead wires (black, orange, yellow) connected to Terminal
Fuse (if used)
Put Fuse to the place
as drawn below.
Fuse
Do not put Fuse
onto this Rib.
Wiring in Handle
Controller unit's lead wires (blue, red) with Connector
Rib H
Switch
Rib G
Inner wall of Housing
Rib J
Line filter
Switch
Inner wall
Fix the above lead wires
with this lead wire holder.
Rib I Connector
Pass Lead wires connected to LED
light circuit between Rib J and
the inner wall of Housing.
Fix Lead wires connected to LED
light circuit with Lead wire holders.
Rib C
Rib D
Rib E LED light circuit
Do not put any lead wires onto
Ribs C, D, E and F.
Set LED light circuit to Handle L while facing
the wire connected portion to Front side.
P 18/ 18
Rib F
Wire connected portion
Front side
(Lever 54 side)