Wiring Diagram - Makita DPB181 Technical Information

W
iring diagram
Fig. D-2
When DC motor is mounted to Housing L,
check the following.
• Route the Lead wires to Housing L side.
• Red marking is located as drawn to the right.
Fig. D-3
Red marking
DC Motor
Fig. D-4
Facing the wire connected side to Handle L side,
set Controller to Handle L.
And push Controller until it stops.
And then, make sure that any of its Lead wires
do not cross over the joint line of Handle L' s edge.
Wiring to DC Motor
DC Motor
Wiring in Motor Housing R
Lead wire (blue) of Controller unit has to be put
under Flag receptacle of Lead wire (red).
Rib A
Line filter
Pass the Lead wires through Line filters.
Lead wire
holder A
Rib B
Lead wire
holder B
Setting of Controller to Handle L
Lead wires
Red marking
Put one Line filter between Rib A
and Lead wire holder A.
And put another one between Rib B
and Lead wire holder A.
Lead wires (red, blue) have to be put
into Lead wire holders A and B.
Joint line
Controller
P 17/ 18
Motor housing R
Handle L