Makita DPB181 Technical Information page 10

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -4. Lever Shaft (cont.)
ASSEMBLING
(3) Mount Ring spring 12 to Lever 54 as drawn in Fig. 12.
Fig. 12
Using 1R242 as a guiding jig, set Ring spring 12 from the opposite side of Grip portion.
Note: Refer to the following drawings for the proper direction of Ring spring 12.
Grip portion
(4) Assemble Lever holder to Frame with four 4x18 Tapping screws. (Refer to the upper right drawing in Fig. 10)
(5) Mount Lever 54 over Lever shaft as drawn in Fig. 13.
Fig. 13
Face the grip portion of Lever 54 to the release mark side, and mount
the lever to Lever shaft while aligning the lever to the guide line.
"Tension mark"
Lever holder
Lever shaft
1R242
Ring spring 12
Grip portion of Lever 54
"Release mark"
Guide line for Lever setting
to release position
P 10/ 18
Ring spring 12