Memory Stick Cover; Camera Window Assembly - Sony Ericsson P910a Working Instruction, Mechanical

15. Install the two M1.4 x 4MM screws that hold the
antenna using a torque driver set at 7 N*cm with
a JCIS No. 0 bit.
• Perform the steps of the "Reassembly" section to complete the reassembly of this phone.

4.20 Memory Stick Cover

The removal and installation of this part is covered in the "Back Cover" section of this document.
Assume that this part is being replaced instead of the back cover. A new part should be used in
the place of the old part when reassembling. Limit the amount of disassembly to only that which
is needed to replace this part.

4.21 Camera Window Assembly

The removal and installation of this part is covered in the "Back Cover" section of this document.
Assume that this part is being replaced instead of the back cover. A new part should be used in
the place of the old part when reassembling. Limit the amount of disassembly to only that which
is needed to replace this part.
3/00021-1/FEA 209 544/90 A

Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Working Instruction, Mechanical
50(62)