Sony Ericsson P910a Working Instruction, Mechanical page 3

NOTE!
4. With the flip in the closed position, slide the flat
end of a pry tool under one of the accessible
corners of the flip hinge cover and rotate the pry
tool away from the system connector. The hinge
cover should start to separate from the phone
along the edge adjacent to the system connector.
5. Once you have got the separation of the flip
hinge cover started, work the pry tool along the
flip hinge cover's separating edge to finish
releasing it from the phone.
6. Once the edge of the flip hinge cover is released
from the phone, lift the hinge cover's free edge
up and out away from the phone as shown. The
flip hinge cover should easily slide out from
between the flip and the front cover when lifted
in the manner shown.
7. Using a torque driver with a JCIS No. 0 bit,
remove the two M1.4 x 3.5MM screws holding
the flip assembly.
NOTE!
3/00021-1/FEA 209 544/90 A

Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Be careful not to scratch or scar the
phone or the flip hinge cover when
removing the flip hinge cover.
Do not reuse the screws that hold the
flip assembly in place.
Working Instruction, Mechanical
3(62)