Sony Ericsson P910a Working Instruction, Mechanical page 32

22. Insert the jog dial into the new back cover so that
the dial portion protrudes through the slot in the
side of the back cover and the two wings of the
gull wing portion of the jog dial are aligned with
the their corresponding back cover notches.
23. Press one of the jog dial's wings into its
corresponding notch in the back cover until the
wing snaps into place.
24. Press the other wing into its corresponding notch
in the back cover until the wing snaps into place.
The jog dial is now installed.
25. Using a pair of tweezers, work the vibrator from
its cavity by gently lifting the vibrator by its
weight.
NOTE!
26. When installing the vibrator into the new back
cover, orient the vibrator so that its weight is
toward the jog dial, the contacts are facing out
away from the back cover, and the placement
features along each side of the vibrator's boot
are aligned with the corresponding notches in
side walls of the vibrator cavity.
27. Place the vibrator over the vibrator cavity and
gently press it into place.
NOTE!
3/00021-1/FEA 209 544/90 A

Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Be careful not to damage the vibrator
contacts or to bend the shaft of the
vibrator when removing it.
Do not push on the vibrator contacts!
Working Instruction, Mechanical
32(62)