Sony Ericsson P910a Working Instruction, Mechanical page 37

47. Verify that the hole in each screw boss is visible
through the corresponding hole in each end of
the stylus holder. Also verify that the alignment
peg adjacent to each screw boss protrudes
through their corresponding holes in the stylus
holder.
48. With the stylus holder in place, install a M1.4 x
4MM screw in both screw holes and torque the
screws into place using a torque driver set at
7N*cm and a JCIS No. 0 bit.
3/00021-1/FEA 209 544/90 A

Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Working Instruction, Mechanical
37(62)