Rf Port Cover; Battery Cover; Display - Sony Ericsson P910a Working Instruction, Mechanical

4.3

RF Port Cover

Tools:
1. Orient the phone so that the side of the phone
with the camera is towards you and the end of
the phone with the system connector is the
bottom of the phone.
2. Insert the pointed end of the nylon pointer into
small hole in the RF port cover and rotate the
nylon pointer down towards the outer edge of the
phone. The RF port cover should lift from it
cavity.
3. Insert a RF port cover into the RF port in the
back cover.
NOTE!
4.4

Battery Cover

The removal and installation of this part is covered in the "Disassembly" and "Reassembly"
sections of this document. Limit the amount of disassembly to only that which is needed to
remove this part. If this part is being replaced, a new part should be used in the place of the old
part when reassembling.
4.5

Display

The removal and installation of this part is covered in the "Disassembly" and "Reassembly"
sections of this document. Limit the amount of disassembly to only that which is needed to
remove this part. If this part is being replaced, a new part should be used in the place of the old
part when reassembling. Two cushions and a spacer must be mounted on a new display before it
can be used. The installation of these two cushions and the spacer are covered in the
"Reassembly" section.
3/00021-1/FEA 209 544/90 A

Sony Ericsson Mobile Communications AB
• Nylon Pointer
Step-by-Step Instructions
When correctly installed the visible
surface of the RF port cover should be
flush with the outer surface of the back
cover.
Working Instruction, Mechanical
23(62)