Sony Ericsson P910a Working Instruction, Mechanical page 17

NOTE!
24. Adjust the portion flip that contains the contacts
so that the contacts are visible when viewing the
side of the flip assembly with that standard
phone keypad.
25. Mate the contact portion of the flip assembly in
the corresponding features at the bottom of the
front cover.
NOTE!
NOTE!
26. Using a torque driver set at 7 N*cm with a JCIS
No. 0 bit, install the two M1.4 x 3.5MM screws
that hold the flip assembly to the phone.
27. Rotate the flip assembly so that an angle of
~120º is formed between the flip and the display.
NOTE!
3/00021-1/FEA 209 544/90 A

Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Be careful when handling and adjusting
the portion of the flip assembly that
contains the contacts so that
contamination of the contacts is
avoided.
The screw holes in the contact portion of
the flip assembly should align with the
screw inserts in the front cover.
The M1.4 x 3.5MM screws that hold the
flip assembly in place cannot be reused
and must be replace whenever they are
removed.
You may have to hold the flip at the
120º angle.
Working Instruction, Mechanical
17(62)