Table of Contents
Advertisement
2.8.1.
Audio insertion
This interface can only insert video signals into the factory infotainment. Audio insertion
must be done by factory audio AUX input, the optionally available AUX-in interface AUX-110
(only for MMI3G, not for MMI3G+) or FM-modulator. The inserted video-signal can be
activated simultaneously to each audio-mode of the factory infotainment.
If 2 AV sources shall be connected to the infotainment, additional electronic is necessary to
switch the audio signals.
2.8.2.
After-market rear-view camera
Some vehicles have a different reverse gear code on the CAN-bus which the included CAN-
box is not compatible with. Therefore, there are two different ways of installation. If the
CAN-box detectes the vehicle's reverse gear, the green wire of the 6pin to 8pin cable should
carry +12V while the reverse gear is engaged.
Note: Do not forget to set dip5 of video-interface to ON before testing.
2.8.2.1. Case 1: CAN-box detects reverse gear
If the CAN-bus interface delivers +12V on the green wire of the 6pin to 8pin cable when
reverse gear is engaged, the video interface will automatically be switched to the rear-view
camera input CAM while reverse gear is engaged.
Additionally, the +12V (max. 500mA) power supply for the rear-view camera can be
taken from the green wire of the 6pin to 8pin cable.
Version 09.08.2021
HW CAM(V31),(V22)
CI-RL2-MMI3G-GW/Q3
Advertisement
Table of Contents
