Table 4-1 Status Leds - NEC SL1000 Hardware Manual

ISSUE 1.0
5. Push in and hold the Load button (S1 on the CPU card).
Sub-Cover
Tab
6. Turn the system power on.
7. Continue holding the Load button (S1) for approximately 10 seconds or until Status LED (D5)
starts flashing red.
8. Release the Load button (S1).
9. Wait until the Status LEDs (D2 to D5) on the CPU card has the following indications (approxi-
mately two minutes).
LED No.
D2
D3
D4
D5
10. Turn the power off and remove the CF card from the CF slot on PZ-VM21.
CF card
11. Replace the Main-cover and Sub-cover.
12. Turn the system power back on.
Hardware Manual
Tab
Figure 4-18 Load Button (S1) Location

Table 4-1 Status LEDs

Indication
Flashing Red
Flashing Red
Flashing Red
Off
Figure 4-19 Removing the CF card
CPU card
S1
< Front view >
Remarks
CPU card
CF Slot (CN2)
PZ-VM21 PCB
SL1000
4-11