Perform A Cold Start; Figure 3-2 Power Switch Location; Figure 3-3 Load Button (S1) Location - NEC SL1000 Hardware Manual

SL1000

1.2.1 Perform a Cold Start

This section describes the process for starting the system for the first time or starting a system that
requires the customer data deleting.
System software is loaded from flash memory, and the customer data is deleted
from RAM memory.
If the Expansion KSU(s) is/are installed, turn the power on/off in the order of
Exp 3 KSU, Exp 2 KSU, Exp 1 KSU and then Main KSU.
To perform a Cold Start;
1. Set the power switch is off position.
2. Open the Sub-Cover at the main KSU and make sure the Load button (S1) location on the CPU
card.
Sub-Cover
Tab
3. Connect the AC power cord to the KSU, then plug the AC power cord into an AC outlet.
4. Once the system has powered off, push in and hold the Load button (S1).
If the Expansion KSU(s) is/are installed, the Power Switch must be ON at Expan-
sion KSU(s).
5. Turn the power switch ON at the Main KSU.
3-2

Figure 3-2 Power Switch Location

Tab

Figure 3-3 Load Button (S1) Location

ISSUE 1.0
CPU card
S1
< Front view >
System Start Up