Cleaning; Maintenance - Falcon 1 Series User, Installation And Servicing Instructions

3.1 CLEANING

3.1.1 Switch off appliance and cool down
3.1.2 The air filter is located at the rear of the unit. It can be removed by sliding upwards
from the guide. Clean using hot soapy water and refit after drying.
3.1.3 Clean the Ceran-glass hob with hot soapy water and a soft cloth. DO NOT USE metal
scrapers.
3.1.4 Enamelled surfaces within oven chamber approved cleaning agents which bear the
Vitreous Enamel Development Centre (VEDC) mark are recommended.
3.1.5 With regards the oven chamber, Wipe enamelled surfaces clean while still warm. Use
a soft cloth and hot soapy water. Badly stained removable parts should be soaked in
hot water with an approved detergent using nylon or scotch cleaning pads will provide
good results.

3.2 MAINTENANCE

3.2.1 Oven door catch may need to be occasionally lubricated. Push down on roller and
apply high melting point lubricate inside the catch and onto roller itself.
3.2.2 If there are issues with closing of the door, try adjusting the catch Use your hands or
an appropriate implement to push down on the roller 1 as shown. Whilst holding it
down, turn it right 2 to adjust it down, or left 3 to adjust it up as shown.
CLEAN THE AIR INTAKE FILTER REGULARLY. FAILURE TO
CLEAN THE FILTER REGULARLY MAY CAUSE PROBLEMS
WHICH WILL NOT BE COVERED BY WARRANTY. THE AIR
INTAKE FILTER MUST BE IN-PLACE DURING OPERATION.
DO NOT ATTEMPT TO REPAIR OR REPLACE ANY PART OTHER
THAN THE AIR INTAKE FILTER. REFER TO THE ERROR CODE
LIST TO DEBUG THE PROBLEM.
9