Falcon 1 Series User, Installation And Servicing Instructions page 4


This appliance may be discoloured due to testing.

These instructions are only valid if the country code appears on the appliance. If
the code does not appear on the appliance, refer to the technical instructions for
adapting the appliance to the conditions for use in that country.

Installation must meet national or local regulations. Attention must be paid to:
safety (installation & use) regulations, health and safety at work act, local and
national building regulations, fire precautions act.

To prevent shocks, this appliance must be earthed.

This unit is fitted with an equipotential connection at the rear on the base.

This appliance has been CE-marked on the basis of compliance with the Low
Voltage and EMC Directives for the voltages stated on the data plate.

This equipment is for professional use only and must be used by qualified
persons.

The installer must instruct the responsible person(s) of the correct operation and
maintenance of the appliance.

Unless otherwise stated, parts which have been protected by the manufacturer
must not be adjusted by the installer.

The appliance must be serviced regularly by a qualified person. Service intervals
should be agreed with the service provider.

Check that no damage has occurred to the appliance or supply cord during transit.
If damage has occurred, do not use this appliance.

Ensure the supply cord is routed free from the appliance to avoid damage.

The appliance has been designed and approved to use Falcon kick plates; non
Falcon kick plates could potentially adversely affect the performance of the
appliance by restricting the air to the appliance.

All apparatus connected to a potable water network and including water drain
device has to be provided with an air break before its discharge to the drainage
system. Type AA.