Falcon 1 Series User, Installation And Servicing Instructions page 26

7.4.3 Un-fasten four screws on inner cradle assembly pull cradle forward and tilt down.
7.4.4 Disconnect generator wires from three way terminal block. Remove wiring, noting
connection positions.
7.4.5 Unplug 8 Pole ribbon cable from PCB display board. Un-fasten two screws per
generator. Whilst removing induction generator from the cradle assembly feed
electrical cables out of the cable entry holes.
7.4.6 When re-fitting feed cable back into cable entry holes and position generator into the
cradle. Ensure Generator is placed between the stop at the rear of the cradle. Fit two
screws and secure the generator in place on the cradle. Reconnect the 8 Pole ribbon
cable onto display board.
19