How To Announce Emergency Messages - Honeywell Gent Vigilon Compact Operating Instructions Manual

How to announce emergency messages

Evac.
Alert
or Bomb
On
Flashing
Voice Alarm Zones
1
Or
All Zones
Emergency messages
1
Alert
n
VA Activated
Ceiling
loudspeaker
Attention tone followed by
announcement of
Pre-recorded messages
Silence Alarms
If an emergency situation should occur, you can announce 'fire alert', 'fire evacuate'
and 'bomb alert' messages to selected local voice alarm zones.
.
n
2 3
Evacuate Bomb
n n
Factory default Standard messages
Evacuate message follows an attention tone:
"An incident has been reported in this building please await further
instructions."
Alert message follows an attention tone
"This is a fire alarm please leave the building immediately by the nearest
available exit."
Bomb alert message follows an attention tone
"May I have your attention please, an incident has been reported in the area,
as a precaution please move away from all windows, further information will
follow shortly."
Vigilon
Open the panel door.
Select the Voice Alarm Zones
emergency message are to be announced,
notice that the two green-red LEDs on either
side of the button flash alternately.
"
If you need to deselect a selected
zone then press the button again.
To select all zones press the All
Zones button and note the All Zone
green next to the button is lit.
Press the required Emergency message
button:
No.1 ALERT
(if selected its red LED will be On)
No.2 EVACUATE
(if selected its red LED will flash)
No.3 BOMB
(if selected its red LED will flash)
Notice also that the LEDs of the selected
Voice Alarm Zone buttons are lit giving either
steady or flashing indication depending on
the
message number selected.
The VA Activated LED is lit and the system
will sound an attention tone followed by the
selected emergency message, this sequence
will be repeated until the alarms are silenced.
:
:
When the emergency is over and to stop the
announcement, press the Silence Alarms
button.
COMPACT VOICE ALARM
in which the
15