How To Announce An Auxiliary Message - Honeywell Gent Vigilon Compact Operating Instructions Manual

How to announce an auxiliary message

There are three auxiliary messages at the control panel and these are factory set to
Auxiliary
announce a 'start of fire alarm test', 'end of fire alarm test' and a 'stand down' to inform
Message
that the emergency is over. An auxiliary message can be selected at the control panel for
1, 2 or 3
announcement in selected voice alarm zone(s) of the system.
"
All Auxiliary messages are single shot messages, that is the message will play
once only. To make a repeat annoucement you will need to repeat the following process.
On
Flashing
Voice Alarm Zones
1
Or
All Zones
Auxiliary messages
2
n
Ceiling
loudspeaker
Attention tone followed
by announcement
are pre-recorded messages
Red range
7 5 3
20 10 0 3
-
60 80 100%
40
20
0
vu
Clear Zones
Open the panel door.
Select the
n
announcements are to be made, to do this
press the required
number(s), notice the two green - red LEDs
on either side of the button flash alternately.
If you need to deselect a selected zone then
press the button again. To select all zones
press the All Zones
Zone green LED is lit.
Press the required
No.1 Test Start message
No.2 Test End message
No.3 Stand down message
(when selected the green LED above the
selected button will be lit)
Notice also the left LED of the selected
Alarm Zone
Factory default standard messages
Auxiliary 1 message follows an attention
tone:
"Attention please, attention please, this is the
test of the fire and voice alarm system, there is
no need to take any action."
Auxiliary 2 message follows an attention
tone:
"The test of the fire and voice alarm system has
now been completed."
Auxiliary 3 message follows an attention
tone:
"May I have your attention please, the cause of
the alarm has been investigated and the system
reset. There is no cause for concern. Thank
you."
To stop the announcement at any time press
the Clear Zones
will either play out or stop immediately
dependent on how your system is
configured.
Vigilon
Voice Alarm Zones in which
Voice Alarm Zone
button and note the All
Auxiliary message
buttons are lit.
button. The announcement
COMPACT VOICE ALARM
button:
Voice
19