Appendix 1 - Event Log Messages - Honeywell Accenta Series Engineer's Manual

Accenta/Optima Engineer's Manual

Appendix 1 - Event Log Messages

KEYPAD TEXT
Zone events
INTRUDER
ENTRY START
ZONE OMITTED
FIRE ZONE
ZONE EXCLUDED
User Events
CODE ENTRY
SET PROGRAM
SYSTEM UNSET
System Events
CLEAR LOG
NVM INIT
START UP
PA
RKP PA
DURESS CODE
ENTRY TIMEOUT
SYSTEM REARM
CODE TAMPER
USER RESET
ENG'R RESET
ENG ACCESS
ENG FINISH
OLD TIME
NEW TIME
OLD DATE
NEW DATE
MAINS FAIL
MAINS OK
LOOP TAMPER
Intruder zone activated (opened)
Entry time started
Zone has been omitted for one set period
Fire zone activated (opened)
Zone has been omitted for one set period
User has entered code
User has set the system with program 1, 2 or 3
User has unset the system
Event log has been cleared
Panel was set to factory default conditions
Panel was cold started
PA zone activated
Remote Keypad PA enabled
Duress code used to set or unset the system
Timeout alarm after entry time has expired
System rearmed after an alarm
Invalid user code was entered
User has reset the system
Engineer has reset the system
Entering engineer program mode
Leaving engineer program mode
Old time indicated before change
New time indicated after change
Old date indicated before change
New date indicated after change
Mains power supply failure
Mains power supply restored
Tamper alarm indicated
Table 4. Event Log
47
Event Log
DESCRIPTION