Operating instructions
Replacing broken glass on an old
Manual call point
&
Take appropriate
precautions when clearing broken
glass to prevent injury.
"
A weather resistant version of
the manual call point will have two
gaskets, a Cover/glass gasket and a
Spacer/cover gasket, which must be
installed in their respective positions.
THUMB WHEEL
FIRE
BREAK GLASS
SLIDER
THUMB WHEEL
a
These procedures assume the cover on the manual
call point has been removed and any broken glass
has been cleared.
a.
Feed the glass upward to push the cams down
and fit it under the slider, locate bottom of glass
into recess.
b.
Hold the bottom of glass in position and rotate
the thumbwheel quadrant to raise the top of the
glass.
c.
Fit the call point cover by hooking it into the top
of the unit, making sure that the glass is
properly seated (held down) tighten the cover
fixing screw.
d.
Test that the manual call point functions
correctly.
40
SLIDER
CAM
Battery replacement
It is recommended that batteries are replaced at
4 yearly intervals from the date the Vigilon compact
system is first commissioned.
"
system must be carried out by a suitably
trained person, such as one from the
servicing organisation.
&
disconnected at the battery box during
servicing.
Printer paper roll
If an optional thermal printer is connected to the panel
and the paper should run out, then ensure
recommended replacement paper roll is used and is
fed into the printer correctly.
¨
PRINTER-H-PAPER for handheld printer.
b
Any servicing work on the
Ensure the batteries are