Specifications And Features; Transmitter - Lectrosonics DPR Instruction Manual

DPR, DPR/E01

Specifications and Features

Transmitter

Operating Frequencies:
Frequency Selection Steps:
RF Power output:
Frequency stability:
Digital modulation:
Spurious radiation:
Equivalent input noise:
Input level:
Input impedance:
Input limiter:
Gain control range:
Modulation indicators:
Encryption:
Audio Performance:
Frequency Response:
Low frequency Roll-off:
Input Dynamic Range:
Controls & Indicators:
Audio Input Jack:
Phantom Power:
IR (infrared) port:
Antenna:
Battery: Two 1.5 Volt AA (lithium recommended)
Battery Life:
AA lithium;
No Phantom Power:
AA lithium;
48V Phantom Power:
Weight:
Dimensions:
Emission Designator:
20
US: 470.100 - 607.950 MHz
E01: 470.100 -614.375 MHz
25 kHz
Selectable 25/50 mW
± 0.002%
8PSK
US: Compliant with
ETSI EN 300 422-1 v1.4.2
E01: Compliant with
ETSI EN 300 422-1 v2.1.2
–125 dBV (A-weighted)
Nominal 2 mV to 300 mV,
before limiting
Greater than 1V maximum, with limiting
1K Ohm
Dual envelope type; 30 dB range
55 dB in 1 dB steps; digital control
• Dual bi-color LEDs indicate
modulation of -20, -10, 0, +10 dB
referenced to full modulation
• LCD bar graph
AES 256-CTR
(per FIPS 197 and FIPS 140-2)
25 Hz to 20 kHz, (+0, -3dB)
Adjustable for -3dB @ 25, 35, 50, 70,
100, 120 and 150 Hz
110 dB (A), before limiting
125 dB (with full Tx limiting)
• LCD w/membrane switches
• LED audio level indicators
Standard 3-pin XLR (female)
5V @ 18 mA max., 15V @ 15 mA max.
and 48 V @ 4 mA max., plus "OFF"
For quick setup by transferring settings
from an IR enabled receiver
Housing and attached microphone form
the antenna.
6h 0m*
3h 30m**
*Tested with a dynamic microphone
**Tested with a Sanken CS1 for a
phantom-powered microphone
7.8 ozs. (221 grams)
4.21" L [excluding antenna: DPR-A] x
1.62" W x 1.38" H
(106.9 L x 41.1W x 35.0 H mm)
170KG1E
Recorder
Storage media:
File format:
A/D converter:
Sampling rate:
Recording modes/Bit rate:
Input:
Type:
Input level:
Input connector:
Timecode:
Connector:
Signal voltage:
Input impedance:
Format:
Audio Performance:
Frequency response:
Dynamic range:
Distortion:
Operating temperature range:
Celsius:
Fahrenheit:
For body worn operation, this transmitter model has
been tested and meets the FCC RF exposure guidelines
when used with the Lectrosonics accessories supplied or
designated for this product. Use of other accessories may
not ensure compliance with FCC RF exposure guidelines.
Contact Lectrosonics if you have any questions or need
more information about RF exposure using this product..
This device complies with FCC radiation exposure limits as
set forth for an uncontrolled environment. This device should
be installed and operated so that its antenna(s) are not co-
located or operating in conjunction with any other antenna
or transmitter.
microSDHC memory card (HC Type)
.wav files (BWF)
24-bit
48 kHz
HD mono: 24 bit - 144 kb/s
Analog mic/line level compatible; servo bias
preamp for 2V and 4V lavaliere microphones
• Dynamic mic: 0.5 mV to 50 mV
• Electret mic: Nominal 2 mV to 300 mV
• Line level: 17 mV to 1.7 V
TA5M 5-pin male
3.5 mm TRS
0.5 Vp-p to 5 Vp-p
10 k Ohms
SMPTE 12M - 1999 compliant
25 Hz to 20 kHz; +0.5/-1.5 dB
110 dB (A), before limiting
125 dB (with full Tx limiting)
< 0.035%
-20 to 50
-5 to 122
LECTROSONICS, INC.