Qinq Vid - H3C S5120-EI Series Command Reference Manual

[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable
[Sysname-GigabitEthernet1/0/1] qinq transparent-vlan 2 3 50 to 100

qinq vid

Syntax
qinq vid vlan-id
undo qinq vid vlan-id
View
Layer 2 ethernet interface view, Layer 2 aggregate interface view, port group view
Default Level
2: System level
Parameters
vlan-id: Outer VLAN ID, ranging from 1 to 4094.
Description
Use the qinq vid command to enter QinQ view and configure the outer VLAN tag for the port to add.
Use the undo qinq vid command to remove all configurations corresponding to the outer VLAN ID
performed in QinQ view.
By default, the outer VLAN tag is the port's default VLAN tag.
Configured in Ethernet interface view, this command takes effect on the current port only.
Configured in port group view, this command takes effect on all ports in the port group.
Configured in Layer 2 aggregate interface view, this command takes effect on the Layer 2 aggregate
interface and the member ports in its aggregation group. You can configure this command on a Layer 2
aggregate interface and its member ports separately. Configured on an aggregation member port, this
command takes effect immediately. For more information about link aggregation, see the Layer 2—LAN
Switching Configuration Guide.
Related commands: raw-vlan-id inbound and qinq ethernet-type.
Examples
# Configure GigabitEthernet 1/0/1 to tag frames with outer VLAN 10.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable
[Sysname-GigabitEthernet1/0/1] qinq vid 10
# Configure all the ports in port group 1 to tag frames with outer VLAN 10.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member gigabitethernet 1/0/1 to gigabitethernet
1/0/6
[Sysname-port-group-manual-1] qinq enable
[Sysname-port-group-manual-1] qinq vid 10
200