Enabling Gvrp Compatibility; Displaying And Maintaining Mvrp; Mvrp Configuration Example; Network Requirements - H3C S5560S-EI Series Configuration Manual

Enabling GVRP compatibility

Enable GVRP compatibility for MVRP when the peer device supports GVRP. Then, the local end can
receive and send both MVRP and GVRP frames.
When you enable GVRP compatibility, follow these restrictions and guidelines:
•
GVRP compatibility enables MVRP to work with STP or RSTP, but not MSTP.
•
When the system is busy, disable the Period timer to prevent the participant from frequently
registering or deregistering attributes.
For more information about GVRP, see the IEEE 802.1Q standard.
To enable GVRP compatibility:
Step
1.
Enter system view.
2.
Enable GVRP compatibility.

Displaying and maintaining MVRP

Execute display commands in any view and reset commands in user view.
Task
Display MVRP running status.
Display the MVRP state of a port in a
VLAN.
Display MVRP statistics.
Clear MVRP statistics.

MVRP configuration example

Network requirements

As shown in
•
Create VLAN 10 on Device A and VLAN 20 on Device B.
•
Configure MSTP, map VLAN 10 to MSTI 1, map VLAN 20 to MSTI 2, and map the other VLANs
to MSTI 0.
Configure MVRP on Device A, Device B, Device C, and Device D to meet the following
requirements:
•
The devices can register and deregister dynamic VLANs.
•
The devices can keep identical VLAN configurations for each MSTI.
Command
system-view
mvrp gvrp-compliance enable
Figure 57:
Command
display mvrp running-status [ interface interface-list ]
display mvrp state interface interface-type interface-number
vlan vlan-id
display mvrp statistics [ interface interface-list ]
reset mvrp statistics [ interface interface-list ]
164
Remarks
N/A
By default, GVRP compatibility is
disabled.