Lldp Fast-Count - H3C S5120-EI Series Command Reference Manual

Default level
2: System level
Parameters
None
Description
Use the lldp encapsulation snap command to configure the encapsulation format for LLDPDUs as SNAP
on a port or a group of ports.
Use the undo lldp encapsulation command to restore the default encapsulation format for LLDPDUs.
By default, Ethernet II encapsulation applies.
NOTE:
The command does not apply to LLDP-CDP packets, which use only SNAP encapsulation.
Examples
# Configure the encapsulation format for LLDPDUs as SNAP on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp encapsulation snap

lldp fast-count

Syntax
lldp fast-count count
undo lldp fast-count
View
System view
Default level
2: System level
Parameters
count: Sets the number of the LLDPDUs sent each time fast LLDPDU transmission is triggered. The
argument ranges from 1 to 10.
Description
Use the lldp fast-count command to set the number of the LLDPDUs sent each time fast LLDPDU
transmission is triggered.
Use the undo lldp fast-count command to restore the default.
By default, the number is 3.
Examples
# Configure the device to send four LLDPDUs each time fast LLDPDU transmission is triggered.
<Sysname> system-view
[Sysname] lldp fast-count 4
220