Port Bridge Enable - H3C S5120-EI Series Command Reference Manual

undo port auto-power-down
View
Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Description
Use the port auto-power-down command to enable auto power-down on Ethernet interfaces for energy
efficiency.
Use the undo port auto-power-down to restore the default.
By default, auto power-down is disabled on Ethernet interfaces.
With this function enabled, a port, after being idle for a period, enters the power save mode. When a
packet arrives, the port enters its normal state.
Configure Ethernet ports one by one in interface view or multiple ports in bulk in port group view.
Examples
# Enable auto power-down on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port auto-power-down
# Enable auto power-down on all member ports of port group group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member gigabitethernet 1/0/1
[Sysname-port-group-manual-group1] group-member gigabitethernet 1/0/2
[Sysname-port-group-manual-group1] port auto-power-down

port bridge enable

Syntax
port bridge enable
undo port bridge enable
View
Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use the port bridge enable command to enable bridging on a Ethernet interface.
34