Speakers - HP 200 G4 22 Maintenance And Service Manual

Speakers

1. Prepare the computer for disassembly
2. Remove the display (see
3. Remove the power button/card reader board (see
4. Disconnect the two speaker cables from the system board (1).
5. Pull the speakers off the installation posts and out of the computer (2).
TIP: When installing the speakers, make sure the rubber gasket is in place in the speakers and over the
installation posts (3).
To install the speakers, reverse the removal procedures.
(Preparation for disassembly on page
Display on page 18).
Power button/card reader board on page
16).
30).
Speakers 31