Huawei SUN2000L Series User Manual page 92

SUN2000L-(4.125KTL, 4.95KTL)-JP
User Manual
The Quick setting screen provides two deployment modes. Select either of them based on site
requirements.
To exit the deployment, press the Back button on the mobile phone or tap Exit on the screen.
Method 1: quick setting
Step 1 Choose Quick setting from the Operation console screen and perform deployment by
following the instructions.
Figure 7-26 Quick setting




----End
Issue 03 (2018-04-11)
The page mentioned in Step 1 will be skipped.
Set the grid code that applies to the country or region where the PV plant is located and the
SUN2000L model.
If there is no need to connect to the router or management system, skip relevant steps.
After the connected router is configured, the configuration takes effect after you log out of
the app and then log in again.
After the management system is successfully connected, the SUN2000L will report the SN
and installer registration code number. If the connection fails, another connection attempt
will start after 10 seconds. The installer registration code number is generated by the
SUN2000L automatically and is used for the installer to register with the management
system and manage the inverter.
After following all the instructions on the Quick setting screen, tap Save settings to store
the configurations or tap Return to home to return to the Operation console screen.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Operations on the Local FusionHome App
85