Huawei SUN2000L Series User Manual page 55

SUN2000L-(4.125KTL, 4.95KTL)-JP
User Manual
Procedure
Step 1 Connect signal cables to appropriate signal connectors.






Figure 5-18 Assembling a signal connector
If only one signal cable needs to be connected, block the unused cable hole on the seal using a
cap and tighten the cable gland.
Figure 5-19 Blocking a cable hole
Step 2 Connect the plug to the corresponding port.
Issue 03 (2018-04-11)
The protection layer of the cable is in the connector. Surplus core wires are cut off from
the protection layer.
Ensure that the exposed core wire is totally inserted into the cable hole.
Ensure that the signal cables are connected securely.
Ensure that the cable is not twisted.
If a connector needs to connect to only one signal cable, block the unused cable hole on
the seal using a cap and tighten the cable gland.
If a connector needs to connect to two signal cables, ensure that the cables have the same
outer diameter.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Electrical Connections
48