Monitors; Symbols - Bayer HealthCare MEDRAD 800 Module Operation & Installation Manual

Monitors

Display and Control Unit (DCU)

Symbols

Icon
TX
RX
In some countries, the MEDRAD
purchased with a choice of two monitors, shown below - "Display and Control
Unit (DCU)" and "Certegra
two models, shown below as Model 1 and Model 2. The Certegra Workstation
hardware buttons differ slightly between Models but the screen/monitor
information remains the same.
Throughout the manual, "Display and Control Unit (DCU)" and "Certegra
Workstation" will be used to refer to the two when there are differences in how
information is presented on the screens.
®
Certegra Workstation (Model 1)
The following symbols are used on the ISI 800 Module and its components:
Meaning
Indicates that this device conforms to the requirements of the European
Medical Device Directive 93/42/EEC.
Attention: Refer to warnings and cautions on Instructions for Use packaged
in each carton. (ISO 15223-1, 5.4.4)
Warning: Indicates hazardous voltages. (ISO 7010, W012)
Indicates alternating current. (IEC 60417, 5032)
Indicates scanner connection.
'
Identifies a terminal suitable for direct current. (IEC TR 60878, 5031)
Indicates injector connection.
Identifies the Equipotential connection. (IEC TR 60878, 5021)
Identifies the CAN Interface TRANSMIT LED.
Identifies the CAN Interface RECEIVE LED.
®
Stellant CT Injection system may be
®
Workstation." The Certegra Workstation comes in
Certegra
4
®
Workstation (Model 2)