Bayer HealthCare MEDRAD 800 Module Operation & Installation Manual page 11

The procedure (injection plus scan) can only be initiated by pressing the
start button on the injector.
The procedure (injection plus scan) can only be initiated by pressing the
start button on the scanner.
The procedure (injection plus scan) can be initiated by pressing the start
button on EITHER the scanner or the injector.
The following icons may appear on the Display and Control Unit (DCU) only.
Icon Meaning
When the icon is yellow, as shown, the injector is working in conjunction
with the scanner – it is "coupled". This symbol will only appear on the
screen when the system is in Control or Tracking modes.
When the icon is gray, as shown, the protocol has not been locked.
When the icon is highlighted in yellow, the protocol has been locked.
Labels on ISI 800 Module or statements in this manual preceeded by any of
the following words and/or symbols are of special significance, intended to
help you to operate the system in a safe and successful manner.
WARNING: Indicates that the information is a warning. Warnings advise of
circumstances that could result in injury or death to the patient or operator.
Read and understand the warnings before operating the injection system.
CAUTION: Indicates that the information is a caution. Cautions advise of
circumstances that could result in damage to the device. Read and
understand the cautions before operating the injection system.
NOTE Indicates that the information that follows is additional important
information or a tip that will help the user to recover from an error or point to
related information within the manual.
®
MEDRAD Stellant ISI 800 Module Operation Manual
7