Bayer HealthCare MEDRAD 800 Module Operation & Installation Manual page 10

Icon
The configurations below are determined by the scanner manufacturer. Refer to the scanner
manufacturer instructions for further information. The following description applies to the four icons
below.
1. If the injector and/or scanner icon is gray, as shown below, it is not ready.
2. If the injector icon is yellow but not flashing, it is ready but is waiting for the scanner to be ready.
3. If the scanner icon is yellow but not flashing, it is ready but is waiting for the injector to be ready.
4. If the injector icon is yellow and flashing, an injection can be initiated whether or not the scanner is
ready.
5. If the injector and scanner icons are yellow and flashing, the procedure (injection plus scan) can be
initiated by pressing the start button specified below.
'
Medical - General Medical Equipment As To Electrical Shock, Fire, and
Mechanical Hazards Only In accordance with ANSI/AAMI ES60601-1
(2005) + AMD 1 (2012)
CAN/CSA-C22.2 No. 60601-1 (2014).
See accompanying documentation. This symbol indicates the user shall
refer to the instructions-for-use to ensure safe operation. (ISO 7010, M002)
Consult instructions for use (ISO 15223-1, 5.4.3)
The following icons may appear on the injector screen:
Meaning
Communication between the injector and the scanner has been
established via the ISI 800 Module, which means it is communicating with
both the scanner and the injector.
The ISI 800 Module is communicating with the injector.
The ISI 800 Module is not communicating with the injector.
This icon indicates the injector and scanner are functioning independently.
This icon is also used when the injector is operating without an ISI 800
Module. The Display and Control Unit (DCU) icon is shown. On the
®
Certegra Workstation, the icon is the same but is vertical.
When no arrow is shown between the injector and the scanner, a test
injection is programmed -- a test injection can be started only from the
injector. When the injector icon is highlighted in yellow and blinking, the
injector is ready and the test injection can proceed. After the test injection
is completed, one of the three arrows, as shown below, will appear.
6