Table of Contents
Advertisement
Display and Control Unit (DCU)
Protocol Lock Status Icon (Shown Unlocked)
Display and Control Unit (DCU)
NOTE:
The Display and Control Unit (DCU) screenshots used in this
section show a mixture of Protocol and Profile views.
1. Program the scanner.
2. Program the injection protocol into the injector. Once the protocol has
been programmed, press the Protocol Lock button.
NOTE:
The Protocol Lock button MUST be pressed before the
injector can be armed.
NOTE:
Once the Protocol Lock button has been pressed, the
Protocol Lock icon in the lower left corner of the screen will
be highlighted in yellow.
3. Check the fluid pathway for air. Once any air has been purged, press the
Check For Air button on the injector head.
4. Press the Arm button to arm the injector.
Monitor Mode - Injector Not Ready
Certegra Workstation
Certegra Workstation
12
- Quick Links:
- Installation
- System Overview
Hide quick links:
Advertisement
Table of Contents
