5. Cleaning, maintenance and conversion
1
Manifold block
2
End plate
3
M5 fastening
screws
4
Guide sleeves
5
Separator plate
without channel
separation
Fig. 5/7: Dismantling the right−hand end plate
Festo P.BE−CDVI−EN en 0702c
Fitting/removing the right−hand end plate
Dismantling
1. Release the right−hand end plate of the CDVI by loosening
the two M5 screws in the end plate by one turn.
2. Then unscrew and remove the M5 screws from the base
block.
3. Remove the end plate from the base block of the CDVI.
1
5
2
3
4
5−23