Speed Dial Pause And Flash/Recall Storage; Speed Dial Number Linking - Toshiba Strata CT DKT2510-FS User Manual

Features

Speed Dial Pause and Flash/Recall Storage

Some Speed Dial numbers may require a pause (long or regular) or hookflash be included (e.g., tone
delay requires a pause at the beginning of a Speed Dial number).
Hookflash
The Flash/Recall button stores a
flash signal only if Spd
is programmed as a flexible button on
the telephone. The flash signal is 0.5
or 2 seconds long (set in system
programming) and is displayed on the
LCD as "F-".
Press Flash/Recall
...or enter the hookflash/recall dial
code (Cnf/Trn + #45).

Speed Dial Number Linking

You can link any of the Station Speed Dial numbers to System Speed Dial codes or to any of the
optional buttons associated with these codes. This enables up to 36 digits to be stored under one
Station Speed Dial button or code.
The number directly stored in the System Speed Dial number dials out first, then the number linked to
it. Typically, a company's special carrier access telephone numbers are stored as part of the digit
string.
A designated station can be used to link System Speed Dial codes. See the System
Note
Administrator's User Guide.
Important!
Strata CT Digital Telephone User Guide November 2001
The pause is either 1.5 or 3 seconds (set
Dial
Pause
in system programming). The LCD
displays "P-".
Press Spd Dial Pause
...or if Spd Dial Pause is not on the
telephone, press Flash/Recall to store
a pause.
Before linking Speed Dial Numbers, make sure the System Administrator has stored the
desired number in the System Speed Dial you plan on using.
Regular Pause
Speed Dial–Advanced Features
Long Pause
Ten-second pause, which can be
entered anywhere in the Speed
Dial number. The LCD displays
"L-".
Press Spd Dial Lng Pause.
69