KDK M56RG Operating And Instalation Instructions page 9

2
Loop the Safety Wire to the Ceiling Hook and screw it to the Pipe using Safety Wire Screw. Use the screw which was
removed from Page 4, Step A1.
Safety Wire must fi x correctly.
Can cause injury if Ceiling Fan
drops.
Check Point After Installation
Ceiling Hook
Safety Wire Screw
Safety Wire
Pipe
E) Wiring Instruction
1
1
Connect power supply according to the Wiring Instruction below.
Electrical wiring must be done by competent personnel.
Can cause fi re, electrical shock, Ceiling Fan drops and injuries.
Motor
White
Green/Yellow
Earth
This product is not provided with cord and plug or with other means for connection from the supply. When connect
or change the power cord or lead wire, it must be performed by qualifi ed personnel in order to avoid a hazard.
Please use 227IEC53(RVV) or thickness of tube is 1mm or above. (Other requirements such as diameter of lead
wire, please use according to the regulation of the country). This product should be installed with a double poles
single throw switch (Breaker Switch) with minimum 3mm contact gap in the fi xed installation circuit.
CAUTION
1. The Ceiling Fan is securely fi xed onto the Ceiling Hook.
2. The Safety Wire is loopped to the Ceiling Hook and securely screwed to
the Pipe.
WIRING DIAGRAM
Ceiling Fan
Capacitor
Connector
Black
Red Brown
Black
Brown
Connector
CONNECTING THE POWER SUPPLY
E
Ceiling Fan
WARNING
Regulator
Terminal
Terminal
Live
N
L
Regulator
CAUTION
9
Safety Wire Screw
(with washer)
Check
Live in
Source
Live in
Neutral
Earth
N
Rated voltage is
mentioned on product.
L
Wall switch
(On / Off)