KDK M56RG Operating And Instalation Instructions page 8

Blade must be fi xed correctly.
Can cause no air fl ow.
Can cause injury if blades drop.
Tighten the Blade Screws fi rmly using a
screwdriver.
Can cause injury if Blade drops.
Check Point After Installation
1. The Blade Screws (6 pieces) for securing the Blade Assembly are tightly screwed.
2. Blade Safety Hanger must fi x at the position on Blade.
D) Installation to Ceiling
1
1
Install to Ceiling.
1st step
Take out Pulley Set from Parts Set,
after that cross it to Pipe.
Ceiling Hook
("J" Hook)
1st step
Place the Pulley Set to the Ceiling Hook
as shown in the picture.
Ensure Ceiling Hook can afford more than 10 times the Ceiling
Fan weight.
Can cause injury if Blades drops.
Ensure Ceiling Fan is not tilted so that the Blade does not touch the ceiling during installation.
Can cause unstable air fl ow and effect the Ceiling Fan to wobble.
In case "U" hook is being used, installation method is the same.
Pulley
Ceiling Hook
("J" Hook)
C Hook
2nd step
Place Pulley onto Ceiling Hook.
ALTERNATIVE METHOD
C Hook
Alligned Parallel
2nd step
Incline Pulley Set and install Ceiling Fan.
Make sure the Fan maintain straight to avoid the Blade from
touching the ceiling during installation.
WARNING
ATTENTION
CAUTION
Do not remove Blade Safety Hanger from Blade.
Can cause injury if Blade drops.
Pipe Hole
CAUTION
8
Check
Pulley
"U" hook