KDK M56RG Operating And Instalation Instructions page 10

Should there be a dimmer switch, disconnect it and reconnect the wiring as shown.
Check Point After Installation
1. The wiring is connected properly to the power supply.
Fix the Canopy
F)
1
1
Adjust Upper Canopy position and fi x Upper Canopy
to Pipe fi rmly by screwing them as shown.
The distance of Upper Canopy and Ceiling is
approximately 5mm.
2
2
Pull down Lower Canopy untill it stop and fi x to Pipe fi rmly by screwing them as shown.
Check Point After Installation
1. The Upper Canopy is securely fi xed.
2. The Lower Canopy is securely fi xed.
G) Installation of Speed Regulator
1
1
The dimension for the Speed Regulator is shown in the Diagram.
CAUTION
(80.6)
(9~10)
(4~5)
L 1
L1 L2
(57)
200V Class Regulator
10
Power Supply
Connect
Directly
Dimmer Switch
Ceiling
Approximately 5mm
Upper Canopy
Check
Check