KDK M56RG Operating And Instalation Instructions page 11

2
Loosen the screw from the Speed Regulator Cover. Open the Speed Regulator by lifting up the Speed Regulator
Cover from the base.
Screw
3
Insert the live wire from the wall through the hole of the Speed Regulator Base as shown.
4
Fix the Speed Regulator box to the wall by screwing the screws as shown.
Wood Screw and Wall Plug is not supplied.
5
Connect the Live Wire with the Terminal as shown.
6
To close the Speed Regulator, insert the two holes on top of the
Speed Regulator to the two protruding parts at the base.
Finally, screw them together.
Speed Regulator Base
Switch
L
Wood Screw
Regulator Cover
Live Wire (from power supply)
L 1
Live Wire
1
ATTENTION
11
L 1
Terminal 1
Live Wire (to motor assembly)
Holes
Wall Plug
Live Wire
L 1
Holes
Protruding parts
Screw