KDK M56RG Operating And Instalation Instructions page 7

Safety Wire must be fi xed correctly and connected at
all time.
Can cause injury if Ceiling Fan drops.
Ensure the Safety Wire does not touch the Motor surface.
5
5
Connect the Power Cord to the 3 Pin Terminal.
Make sure all the Terminals are connected
correctly by competent personnel to avoid
electrical hazards.
Can cause fi re, electrical shock, Ceiling Fan
drops and injuries.
Check Point After Installation
C) Assemble Blade Assembly Set To Motor Assembly
1
1
Remove Blade Screw (6 pieces, silver colour) from Motor Assembly.
Step 1 : Assemble Blade towards to the Cover Hook as shown in fi gure step 1.
Step 2 : Tighten the Blades fi rmly with Screws (Silver colour).Each Blade use 2 pieces of Screws.
(Tightening torque for reference : 250-300 N•cm)
Blade hole
Blade Safety Hanger
WARNING
WARNING
1. Switch Lever press the Switch.
2. The Ellipse Bolt, P-R Washer, Spring Washer and Hexa Nut are fi rmly tightened
and the Cotter Pin is inserted and bent for safety reason.
3. Safety Wire Screw is fi rmly tightened.
4. All wires are connected correctly by competent personnel.
Step 1
Cover Hook
Black
Live (Brown)
Earth (Green)
Neutral (Blue)
Live (Brown)
Earth (Green/Yellow)
Step 2
7
Safety Wire
Wrong position
Power cord
Neutral (Blue)
Live (Brown)
Earth (Green)
3 Pin Terminal
Check
Blade Screw (6 pieces)