Table of Contents
Advertisement
M1111 Mill with Dovetail Column
Control Panel
It is vital that you become familiar with the
power controls before operating the Model
M1111 (see Figure 17).
A. Spindle RPM Display: Shows spindle RPM with
an accuracy of +/- 10%.
B. Spindle Rotation Mode: Shows the direction
the spindle is turning.
C. Spindle Mode: Shows STOP when the spindle
is stopped. When spindle is rotating, the
"STOP" indication disappears.
D. Spindle START Button: Press START, and the
spindle will rotate at 200 RPM in the milling/
drilling mode, and the spindle rotation buttons
on the control panel are enabled. The Green
LED tapping lamp will not glow, and the spin-
dle rotation buttons on the ends of the rack
handles are disabled.
E. SPEED Buttons: Press to select a milling/
drilling or tapping RPM. In the milling/drill-
ing mode the range is between 200 and
1750 RPM. In the tapping mode, the range is
between 100 and 500 RPM.
F.
Spindle Rotation Buttons: Press these buttons
to change spindle rotation direction for mill-
ing/drilling operations. Spindle direction can
be changed at any RPM without stopping the
spindle first.
G. Spindle STOP Button: Stops spindle rotation.
If you press the START button, the spindle
speed will return to the last spindle RPM set-
ting.
H. Tapping Button: Switches the mill into tap-
ping mode only when the motor is running.
When in tapping mode, the LED tapping lamp
glows and the RPM automatically drops to
approximately 500 RPM. The spindle rotation
buttons on the ends of the rack handles are
also enabled and the spindle rotation buttons
on the control panel are disabled.
I.
Green LED Lamp: Glows when the machine is
in the tapping mode, and does not glow in the
milling/drilling mode.
J.
Emergency Stop Button: Stops the mill.
Rotate the button clockwise until it pops
back out to reset it.
K. Green Main Power Lamp: Glows when the
main power switch is turned to the ON posi-
tion.
L. Zero Button: Zeros the digital spindle scale.
M. Spindle Height Digital Display: Shows
height of spindle.
N. mm/in Button: Toggles units of measure
between metric and inch conventions.
O. Digital Spindle Scale ON/OFF Button: Turns
the digital spindle scale ON or OFF.
A
E
D
J
M
N
O
Figure 17. Control panel.
-21-
B
C
I
H
F
G
K
L
Advertisement
Table of Contents
