Dimensional Drawings I Tilt Adjustment Angles - ADJ ELEMENT ST HEX User Instructions

Element ST Hex
5" / 127mm
5.12" / 130mm
Element ST Hex
To use the tilt adjustment leg, locate the release button on the bottom of the unit. While sliding the
button back and holding it, carefully slide out the tilt adjustment leg from the base of the unit. After
you have found your desired adjustment level, release the button to lock the leg into place. Make
sure the leg is securely locked into place before setting the unit in its intended location. There are 7
levels of adjustment to select from. See the diagram below to find the desired angle you would like
the unit to sit at.
NOTE: Do not slide the leg out past the last setting (seventh level), due to the fact the leg could
dislodge from the unit.
90°
ADJ Products, LLC - www.adj.com - Element ST Hex User Manual Page 21
85°
73°
81°
69°
Dimensional Drawing
*NOT TO SCALE
Tilt Adjustment Angles
77°
65°