TEC CB-426-T3 Owner's Manual page 28

2.6.3 Media Sensor
Sensitivity
Adjustment (Cont.)
Note:
As soon as the upper two lamps
illuminate green, stop turning the knob.
Note:
As soon as the upper two lamps
illuminate green, stop turning the knob.
20
Feed Gap Sensor Sensitivity Adjustment
(for Label with Gaps)
1 Open the Top Cover.
2 Lift the Pinch Roller Lever to the ROLLER RELEASE position
to open the Pinch Roller Unit.
3 Insert the label with gaps into the Media Inlet so that the Feed
Gap Sensor can detect the LABEL part.
4 Lock the Pinch Roller Unit.
5 Turn on the printer.
6 Turn the Feed Gap Sensor Adjusting Knob to the left most position.
7 Keep turning the knob clockwise slowly. When the upper two
Feed Gap Sensor Lamps illuminate green, the adjustment is
complete.
Feed Gap Sensor Sensitivity Adjustment
(for Media with Rectangular Holes)
1 Open the Top Cover.
2 Lift the Pinch Roller Lever to the ROLLER RELEASE position
to open the Pinch Roller Unit.
3 Insert the media with rectangular holes into the Media Inlet so
that the Feed Gap Sensor can detect the PAPER part.
4 Lock the Pinch Roller Unit.
5 Turn on the printer.
6 Turn the Feed Gap Sensor Adjusting Knob to the left most position.
7 Keep turning the knob clockwise slowly. When the upper two
Feed Gap Sensor Lamps illuminate green, the adjustment is
complete.
Chapter 2 Printer Installation