TEC CB-426-T3 Owner's Manual page 103

A5.4 Parameter
Setting (Cont.)
Note:
Use the FEED or RESTART key
to select a desired value or option.
Specifying the Print Condition for the Print Head Adjustment
The print condition for the X/Y Direction Alignment Test should be
specified before printing.
PRINT DENSITY
Press the PAUSE key. "PRINT DENSITY" appears. Press the
FEED key again.
HEAD ADJUST
Press the PAUSE key.
PRINT CONDITION
Print conditions are ready to be set. Press the PAUSE key.
ISSUE COUNT
The number of copies for the X/Y Direction Alignment Test can
be selected, with a maximum of ten.
After selecting the value, press the PAUSE key.
PRINT SPEED 6"/S
Select the print speed options for printing out the X/Y Direction
Alignment Test: 6 inches/second or 4 inches/second.
After selecting the speed, press the PAUSE key.
SENSOR TRANS
Select the media sensor to be used for printing out the X/Y
Direction Alignment Test: "TRANS" (Transmissive Sensor),
"REFLECT." (Reflective Sensor) or NONE.
After selecting the media sensor, press the PAUSE key.
BACK FEED
Specify whether a back feed will be performed when printing the
X/Y Direction Alignment Test. Select "YES" for back feeding.
After selecting the back feed option, press the PAUSE key.
The message returns to "<2> PARAMETER SET".
Appendix 5
5
YES
System Mode
95