TEC CB-426-T3 Owner's Manual page 102

A5.4 Parameter
Setting (Cont.)
X-Coordinate (-99.5mm to +99.5mm)
X Y Z
- +
Note:
See A5.7.5 for more detail.
Notes:
Use the FEED key for lighter
density, or the RESTART key for
darker density.
The acceptable print density values
are -50 to +50.
The print density value is +0 at
shipment from the factory.
94
X ADJUST +50.0mm
Adjust the X-coordinate.
After entering the value, press the PAUSE key. The message
returns to "<2> PARAMETER SET".
Adjusting Print Density (HEAD 1 and HEAD 2)
POSITION
Press the PAUSE key. "POSITION" appears. Press the FEED
key.
PRINT DENSITY
Print density adjustments are ready to be set. Press the PAUSE key.
HEAD1
Adjust the print density of the color for Head 1.
After selecting the value, press the PAUSE key.
HEAD2
Adjust the print density of the color for Head 2.
After selecting the value, press the PAUSE key.
When the values for both colors are entered, press the PAUSE
key. The message returns to "<2> PARAMETER SET".
Appendix 5
+3
+3
System Mode